The adidas UCL COMPETITION 24/2 5 football is inspired by the design of the official UEFA match ball. Its shell is made of a heat-bonded seamless construction, so it can be played with even in the rain and has greater durability and flight accuracy. The ball is decorated with details of Munich, where the final of this league will be held in 2025. This ball is suitable for official matches, as well as recreational play. The high-quality butyl inner tube ensures good flight properties. The ball boasts a FIFA Quality Pro certificate.
The ball is deflated. If you would like it delivered inflated, please leave us a note with your order.
BENEFITS:
- UEFA official ball design for 2025
- high-quality butyl inner tube
- ideal for training or recreational play
- thermally bonded seamless jacket
FIFA Quality Pro
Balls with the FIFA logo undergo comprehensive testing. The balls produced in this way are approved by FIFA for use in indoor or outdoor games.
Test 1: Ball circumference
To provide a good estimate of the flight path, the ball must have a constant circumference. The circumference is measured at ten different points. These measurements are used to calculate the average circumference. Balls with the FIFA Quality Pro logo must have a circumference between 68.5 and 69.5 cm.
Test 2: Roundness of the ball
Imprecise stitching can deform the ball. The diameter is measured in sixteen places. From these measurements, the average is determined. The two limit values may differ from the average by only 1.5% for FIFA Quality Pro balls.
Test 3: Rebound
A ball is dropped onto a steel plate from a height of two meters ten times.
FIFA Quality Pro can only bounce from 120 cm to 165 cm . The difference between individual bounces must not be greater than 10 cm .
Test 4: Weight
Each ball tested is weighed three times in a special container. This container is sealed so that any air leakage from the ball does not affect the weighing. Balls with the FIFA Quality Pro mark should weigh between 420 and 445 g .
Test 5: Absorption
In this test, the ball is rotated and immersed 250 times in a container with 2 cm of water. FIFA Quality Pro can only absorb 10% of its original weight.
Test 6: Pressure loss
The behavior of a ball that loses pressure during play is difficult to predict. In this test, the ball is inflated with air to a pressure of one atmosphere. After three days (72 hours), the pressure in the ball is measured again. In order for the ball to carry the FIFA Quality Pro mark, it must not lose more than 20% of its original pressure.
Test 7: Stability of shape and size
In this test, the ball is shot 2,000 times against a steel plate at a speed of 50 km/h. The seams and inner tubes must withstand this test without damage. The loss of pressure and the change in the shape and circumference of the ball must be minimal. Only balls with the FIFA Quality Pro seal undergo this test.
Test 8: Balancing the ball
The ball is set in a straight line so that it rolls on a horizontal surface in a straight line and the number of degrees the ball deviates from its original straight path is recorded. Only balls designed for futsal undergo this test. FIFA Quality balls can deviate by a maximum of 5°.
Celý popis >
